VORTEX OP TOILET 39315000 99.0567.131/ECN 252060/10.21 Installation Manual Thank you for selecting our products which have been the benchmarks of fine quality for years.To help ensure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also review the recommended tools and materials in the list, carefully unpack and examine your new plumbing fixture.
PIPING PREPARATION AND CONNECTING WASTE PIPE AND WATER SUPPLY VALVE 4” Unit: mm Unit: mm WATER SUPPLY PIPE : Connecting size ” WATER PIPE(Fig. 1.1/1.2): Size 4” (PVC. pipe class 8.5 or a regular pipe with an internal diameter of 102 mm.) at the connecting point with the toilet and a gradient of 2 cm.
Page 10
Plastic Cover Rubber Cutting of support rod as figure Remove connector parts before Shows the connector after shown. cutting. cutting. - 3 -...
Page 11
I �.._ • In case length of "A" is less than 305 mm. but not lower Plastic Cover than 245 mm. B= 40 -(305 -A) Rubber = 40 + (305 - A) • In case length of "A" is greater than 305mm. but not over •...
Page 12
INSTALLATION THE PLASTIC CONNECTOR INTO THE WALL (P-TRAP) 7.1) Insert the plastic connector into the waste pipe on the wall up to protruding lenght of 318 mm. as shown in figures 7.3 NOTE : (If necessary, apply PVC cement solvent (not supplied) around the end tip of plastic connector t o be fitted with the waste pipe to strengthen the connection joint between waste pipe and plastic connector)
Do not use cleaners in tank. Products containing chlorine(calcium hydrochlorite) can seriously damage fitings in the tank. This damage can cause leakage and property damage. GROHE shall not be responsible or liable for any tank fitting damage caused by the use of cleaners containing chlorine (calcium hydrochlorite)
Need help?
Do you have a question about the 39315000 and is the answer not in the manual?
Questions and answers