Sealey AK2976 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
▲ IMPORTANT: Read these instructions for use carefully, so as to familiarize yourself with the appliance before connecting it to its gas
cartridge, or gas cylinder. Keep these instructions for future reference.
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment, make sure you know where the nearest fire extinguisher is.
WARNING! This appliance shall only be used with the butane refill canister or butane-propane mixture gas refill canister that
‰
complies with EN417 standard. It may be hazardous to attempt to fit other types of gas cartridges or gas cylinders.
This appliance may be filled with any canisters marked 'Butane' complying with EN417.
9
WARNING! Always wear approved eye/ face protection when operating the torch.
‰
WARNING! DO NOT use the torch if you notice that it is damaged or if there could be a gas leak from it. If leaking, remove the torch
‰
to a well ventilated open area and cover with a damp cloth.
WARNING! Butane gas is extremely flammable, handle with care.
‰
WARNING! Always point the torch away from the eyes and body when igniting and during operation.
‰
WARNING! DO NOT put the torch down when it is lit, DO NOT leave it unattended.
‰
WARNING! The flame is not easily visible in bright daylight.
‰
WARNING! Ensure the flame is completely extinguished after use. DO NOT use water to cool the torch down.
‰
WARNING! Only use in a well ventilated area.
‰
WARNING! Assembly and adjustment made in the factory shall not be modified. It can be dangerous to try to modify the adjustment
‰
or the construction of the appliance, to dismantle some parts or to use components other than those recommended."
DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard.
8
Keep flammable material away from the torch when operating.
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT hold any workpiece by hand.
8
DO NOT use grease or oil with parts in contact with oxygen."
8
DO NOT attempt to touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT operate the torch if it is damaged as this may cause failure and/or possible personal injury.
8
DO NOT use the appliance if it has worn seals.
8
DO NOT touch the top of the torch during or immediately after use, as it will be very hot. Allow to cool.
8
DO NOT allow children to operate the torch. Keep unit out of reach of children.
8
After use, allow the torch to cool before storing it.
9
When not in use, store away from direct sunlight in a safe, dry, childproof location.
9
DO NOT store at over 40°C, such as in a car in hot weather.
8
DO NOT modify the appliance.
8
When filled, it will contain flammable gas under pressure.
9
DO NOT puncture or put in fire.
8
Make sure the fire is off before refilling.
9
DO NOT keep lit for more than 5 minutes.
8
NOTE: If there is a leak on your appliance (smell of gas), take it outside immediately into a well-ventilated flame free location where
the leak may be detected and stopped. If you wish to check for leaks on your appliance, do it outside. DO NOT try to detect leaks
using a flame, use soapy water
Allow the micro torch to cool down before storage. Store the appliance in a well ventilated and dry area and ensure the flame is out
9
after the operation.
Use only Sealey original spare parts.
9
DO NOT use torch as a cigarette lighter.
8
Be extra careful when using the torch outdoors on sunny or windy days. Wind may carry the torch's heat back toward you or other
9
areas which are not intended to be heated.
The appliance must be used in a well-ventilated location in accordance with national requirements, for the supply of combustion air
9
and to avoid the dangerous building up of un-burnt gases for appliances not fitted with a flame supervision device.
The appliance shall be operated on a horizontal surface"
9
Always check to make sure no unintended parts or materials are being heated.
9
Operate at least 500mm away from any adjacent surfaces i.e. walls / ceiling.
8
Whenever there is a possibility that unintended material has been heated, wait at least two hours before leaving the area.
9
© Jack Sealey Limited
3-IN-1 BUTANE SOLDERING IRON KIT, QUICK
RELEASE
MODEL NO:
Wear protective Hot surfaces
gloves
Original Language Version
AK2976
AK2976 Issue 1 17/10/2024