Andset Sound Signals; Roubleshooting Guide; Telephone Solutions - GE 21098GE3 User Manual

PRESS TALK KEY
CHARGING............
Handset Sound Signals
Signal
A long warbling tone (with ringer on)
Three short beeps
One long beep
One short beep (every 7 seconds)
One short beep (during room monitoring) Ring alert tone
Troubleshooting Guide

Telephone Solutions

No dial tone
• Check or repeat installation steps:
Make sure the base power cord is connected to a working electrical outlet.
Make sure the telephone line cord is connected to the base and the wall
jack.
• Connect another phone to the same jack. If it doesn't work, the problem
might be your wiring or local service.
• The handset may be out of range of the base. Move closer to the base.
• Make sure the battery is properly charged (for 16 hours).
• Make sure the battery pack (in the handset) is properly installed.
Indicates CID number is Direct Dial Number (DDN)
and cannot be formatted.
This occurs when the handset is placed on the
cradle after the battery is inserted. The handset
needs to be fully charged before it can function
properly
Meaning
Signals an incoming call
Page signal
Confirmation tone for the
completion of a function
Low battery warning
67