GE Monogram ZDP304NPSS Owner's Manual page 39

30″, 36″ and 48″ professional dual fuel ranges
Hide thumbs Also See for Monogram ZDP304NPSS:
Table of Contents

Advertisement

Available languages

Available languages

PROBLEM
TIMER DOES NOT WORK • The timer cannot be used while the oven is self-cleaning.
OVEN
TEMPERATURE
TOO HOT OR
TOO COLD
OVEN DOOR WILL
NOT OPEN AFTER
A CLEAN CYCLE
"CLOSE door"
SCROLLS IN
THE DISPLAY
IS ON WHEN YOU
WANT TO COOK
F- AND A NUMBER
FLASH IN THE DISPLAY
DISPLAY GOES BLANK
UNABLE TO GET
THE DISPLAY TO
SHOW "SF"
"PROBE" APPEARS
IN THE DISPLAY
SHOWS IN DISPLAY
POWER OUTAGE
STEAM FROM
THE VENT
BURNING OR
OILY ODOR
EMITTING FROM
THE VENT
STRONG ODOR
FAN NOISE
The Problem Solver
POSSIBLE CAUSE
• Oven thermostat needs adjustment. See the Oven thermostat
adjustment section.
• The oven is too hot. Allow the oven to cool below locking temperature.
• The self-clean cycle has been selected but the door is not closed.
Close the oven door. The
• The oven door is locked because the temperature inside the oven has
not dropped below the locking temperature. Turn the Oven Mode Selector
and the Temperature knobs to OFF. Allow the oven to cool.
• The oven has a function error code. Turn the Oven Mode Selector and the
Temperature knobs to OFF. Allow the oven to cool for one hour. Put the
oven back into operation.
• Disconnect all power to the oven for 30 seconds and then reconnect
power. If the function error code repeats, call for service.
• The display is blank when the oven or timer is not in use.
• A fuse in your home may be blown or the circuit breaker tripped.
Replace the fuse or reset the circuit breaker.
• The TIMER and the MINI-KNOB buttons must be pushed at the
same time and held for 4 seconds.
• This is reminding you to enter a probe temperature after plugging in
the probe. Enter a probe temperature.
• The Sabbath mode has been selected.
• If the oven was in use during a power outage or surge, the oven must be
reset. Turn the Temperature knob and the Oven Mode Selector to OFF.
Reset the controls to begin again.
• When using the convection mode, it is normal to see steam coming
out of the oven vent. As the number of racks or amount of food being
cooked increases, the amount of visible steam will increase.
• This is normal in a new oven and will disappear in time.
• This is temporary. An odor from the insulation around the inside of the
oven is normal for the first few times the oven is used.
• A cooling fan or a convection fan (depending on the function you are using)
may turn on. This is normal. The cooling fan will turn on to cool internal
parts. It may run after the oven is turned off. The convection fan may cycle
on and off until the function is over or the door is opened.
Professional Dual Fuel Range
symbol will appear in the display.
39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents