Mounting The Correct Accessory - multicomp pro MP013565 User Manual

ATTENTION! When paint is heated, harmful gases and vapours may
develop. Always wear suitable respiratory protection and ensure adequate
ventilation of the work space.
Old layers of paint may contain lead. Paint containing lead must not be removed with

a heat gun. If in doubt, have the paint checked by an expert.
Before every use, check the electrical tool, cable and plug. Do not use the electrical

tool if it is damaged. Do not open the electrical tool yourself and only have it repaired by qualified

specialist personnel using original spare parts.
Do not misuse the power cord to carry the power tool, hang up the power tool or

pull the plug out of the socket. Keep the power cord away from heat, oil, sharp edges or moving parts.
Damaged or entangled power cords increase the risk of an electric shock.
If the power cord is damaged, it must be replaced by the manufacturer or it's service

agent or a similarly qualified person in order to avoid a safety hazard.
Keep power tools away from rain or moisture. Water penetrating into a power tool increases the risk

of an electric shock.
If the power tool must be used in a moist environment, use a ground fault circuit interrupter.

Using a residual current operated circuit-breaker avoids the risk of electric shock.
Only use suitable extension cables that are fully intact. A harmonised H05RR-F 3 x1.0 mm

rubber type cord is required as a minimum for general use.
Always disconnect the Heat Gun from the power supply when not in use.

Store the heat gun in a dry location out of the reach of children.

Keep your workplace clean and well lit.

Do not over-reach, especially when working on ladders.

Never use to thaw frozen pipes located inside walls or near combustibles.

If you are not sure about the correct setting, start with a low temperature setting
and gradually increase the temperature until you achieve optimum results
7.1

Mounting the correct accessory

Make sure that the tool is switched off and the nozzle has cooled down.

Falling loose nozzle can set an object on fire. Nozzles must be mounted firmly and

secure on the unit.
Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle,

allow the unit to cool down completely or use a suitable tool.
A hot nozzle can set a surface on fire. Place down hot nozzles only on fire-proof

surfaces.
An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use

only original nozzles according to the table that are suitable for your unit.
8 INSTRUCTIONS FOR USE
Always observe the safety instructions and applicable regulations.

Use only one hand to hold the tool, do not place your other hand over the air vents

Prior to operation:
Mount the correct accessory for the application.

Set the desired air temperature.

if applicable
（ （ ） ）
6