Additional Safety Instructions For Heat Guns - multicomp pro MP013565 User Manual

4.4 Power tool use and care
Do not force the power tool. Use the correct power tool for your application. The correct power

tool will do the job better and safer at the rate of which it was designed.
Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be

controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source before making any adjustments, changing

accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
Store idle power tool out of the reach children and do not allow persons unfamiliar with the

power tool of these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
This appliance can be used by children aged from 8 years and above and persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
Maintain power tools. Check for misalignment or sticking of moving parts, breakage of parts

and other condition that may affect the power tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with cutting edges are

less likely to stick and are easier to control.
Use the power tool and accessories etc., in accordance with these instructions and in the

manner intended for the particular type of power tool, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from
intended could lead to a hazardous situation.
4.5 Service
Have your power tool serviced by qualified repair person using only identical replacement parts.

This will ensure that the safety of the power tool is maintained.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a hazard.
5

ADDITIONAL SAFETY INSTRUCTIONS FOR HEAT GUNS

Do not place your hand over the air vents or block the vents in any way.

The nozzle and accessories of this tool become extremely hot during use. Let these parts cool

down before touching.
Always switch the tool off before putting it down.

Do not leave the tool unattended while it is switched on.

A fire may result if the appliance is not used with care, therefore:

be careful when using the appliance in places where there are combustible materials;

do not apply to the same place for a long time;

do not use in presence of an explosive atmosphere;

be aware that heat may be conducted to combustible materials that are out of sight;

place the appliance on its stand after use and allow if to cool down before storing;

do not leave the appliance unattended when it is switched on.

A fire may arise if the appliance is not used with care.

Heat may be conducted to combustible materials that are out of sight. Do not use in a damp

atmosphere, where flammable gases may be present or near combustible materials.
4