Identifying The Network Processor And The Cisco Ios Release Software Version; Other Interfaces - Cisco ubr7111e Hardware Installation Manual

Functional Overview
Table 1-4 Network Processor Memory, Cashe, and Flask Disk Information (continued)
Memory Type Size
Primary cache 32 KB (instruction),
32 KB (data)
External cache 2 MB (fixed)
Flash disk 48 MB and 128 MB Up to 2
1. One-time programmable.
2. The flash disk card slots are physically identified as slot 0 and slot 1, but are addressed as disk0 and disk1 when using Cisco IOS commands.

Identifying the Network Processor and the Cisco IOS Release Software Version

To identify the processor and software version installed in your Cisco uBR7100 series router, use the
show version command. The following example using a Cisco uBR7100 series router shows sample
output from the show version command:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) EGR Software (UBR7100-P-M), Released Version 12.1(5)EC
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Thu 10-Aug-01 00:56 by
Image text-base: 0x60008968, data-base: 0x60F84000
ROM: System Bootstrap, Version 12.1(5r)EC, RELEASE SOFTWARE (fc1e)
BOOTFLASH: EGR Software (UBR7100-BOOT-M), Released Version 12.1(5)EC
RACK7522_uBR7114 uptime is 21 hours, 45 minutes
System returned to ROM by reload at 05:53:22 PST Wed Aug 17 2001
System image file is "ubr7100-p-mz"
cisco uBR7114 (EGR) processor (revision A) with 57344K/73728K bytes of memory.
Processor board ID 15495273
R527x CPU at 225Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache
Last reset from power-on
X.25 software, Version 3.0.0.
National clock card with T1 controller
2 FastEthernet/IEEE 802.3 interface(s)
1 Cable Modem network interface(s)
125K bytes of non-volatile configuration memory.
46976K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
8192K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x0

Other Interfaces

Console port—Provides access for a local terminal and is equipped with an RJ-45 receptacle.
Auxiliary port—Provides access for a modem for remote access and is equipped with an RJ-45
receptacle.
Two PCMCIA card slots—Contain flash disks or flash memory cards that provide the default Cisco IOS
software image.
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
1-18
Quantity Description
– Processor's primary internal cache
– Secondary external cache for Cisco uBR7100
series processors
Contains the default Cisco IOS image
Chapter 1 Product Overview
Location
Internal to
processor
–
PC Card slot 0
2
and slot 1
OL-5916-01