Field-Replaceable Units; Port Adapters; Flash Disks; Sdram Memory - Cisco ubr7111e Hardware Installation Manual

Chapter 1 Product Overview
Only one downstream connector should be connected and used for data traffic on the network at any one
Note
time. On the Cisco uBR7111 and Cisco uBR7114 routers, the second downstream connector, however,
can be used for local monitoring purposes.
The Cisco uBR7111 and Cisco uBR7111E routers support one upstream port, and the Cisco uBR7114
and Cisco uBR7114E routers support four upstream ports.

Field-Replaceable Units

Cisco uBR7100 series routers have the following field-replaceable units (FRUs):
•
•
•
•

Port Adapters

The Cisco uBR7100 series routers support a wide range of port adapters. Supported port adapters
include: Ethernet, Fast Ethernet, Synchronous Serial, HSSI, ATM, and SONET interfaces, see
Table
For the most current information on the supported port adapters in the Cisco uBR7100 series routers, see
Note
the Cisco IOS release notes or the Cisco Product Catalog at the following URL:
http://www.cisco.com/en/US/products/index.html
All port adapters available for the Cisco uBR7100 series routers connect directly to the router and are
locked into position by a locking tab and two screws (see
documentation at the following URL:
http://www.cisco.com/en/US/products/hw/modules/ps2033/prod_module_series_home.html
OL-5916-01
Port Adapters, page 1-7
Flash Disks, page 1-9
SDRAM Memory, page 1-11
Rack-Mount and Cable-Management Kit, page 1-12
1-1.
Cisco uBR7100 Series and Cisco uBR7100E Series Universal Broadband Router Hardware Installation Guide
Field-Replaceable Units
Figure 1-4). Refer to the specific port adapter
1-7