Cisco SLM2008PT-NA Administration Manual page 27

Advanced Configuration
Port
STEP 1
STEP 2
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide
To avoid creating a loop in the network, be sure you enable LACP before
connecting the ports, and also disconnect the ports before disabling LACP.
LAG port members will have to be configured with the same speed and
NOTE
duplex mode. A user must ensure the LAG member's ports have the same
speed and duplex settings before activating an LACP group.
The Port > LACP Settings window displays the current LACP settings.
To configure the LACP settings, follow these steps:
Click Port > LACP Settings.
Configure the LACP settings.
• Port—Displays the port number.
• Enable LACP—When the check box is checked, LACP is enabled.
• Admin Key—A channel will only be formed between ports having the same
admin key. This only applies to ports located on the same switch. The
default setting is auto.
5
22