Flymo MULTI-TRIM 200 Important Information Manual page 10

T1-a - Cap, T1-b - Cap Release Latch, T1-c - Spool,
T1-d - Spoolholder, T1-e - Slot,
T2-a - Upper Section, T2-b - Lower Section
To remove spool cap
Pull
When refitting the spool cap
pressing firmly DOWN
To replace nylon line.
To fit spool and line complete:
• AVOID ACCIDENTAL STARTING. REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN:- CLEANING AROUND
THE INSIDE OF THE SAFETY GUARD, REMOVING
OR REFITTING SPOOL CAP, MANUALLY FEEDING
OR REPLACING NYLON LINE. (SEE FIGS U & V)
Disconnect from the mains electricity supply.
• Your product is uniquely identified by a silver and black product rating label.
• We strongly recommend that your product is serviced at least every twelve months, more often in a
professional application.
ENGLISH - 4
SPOOL CAP AND NYLON LINE (2 LINES) - T
(T1).
(T1)
CARING FOR YOUR MULTI TRIM
ENVIRONMENTAL INFORMATION
SERVICE RECOMMENDATIONS
GUARANTEE AND GUARANTEE POLICY
• Ensure spool is fully located by gently rotating it
during fitment, whilst keeping the spoolholder
steady.
(T1).
To fit nylon line only:
• Remember !
1. IF YOU HAVE TWO LINES FITTED
IMPORTANT - If your trimmer has 2 lines fitted
always wind the line onto the upper section of
the spool first.
(T2)
complete'
• Never use a damaged trimmer.
Failures not covered by guarantee
Caution!
T3
'To fit spool and line
(Fig W)
(Fig X)