Table of Contents
Advertisement
Problem Solving
When the
When the
Orange
Green
Green
Orange
When the indicators provide no help
If any of the following problems occur and the indicators do not offer a solution, refer to the pages
given for each problem.
●
Projection does not start, the projection area is
completely black, the projection area is
completely blue, etc.
●
p.37
Moving images played on computer are not
displayed.
●
●
p.38
●
Images are fuzzy or out of focus
●
Problems such as interference, distortion or
black & white checked patterns appear.
Problems when projection starts
●
Power does not turn on
36
(operation) indicator is lit or flashing
(warning) indicator is off
Standby condition
If you press
Warm-up in
Warm-up time is approximately 30 seconds.
progress
Power off operations are ignored while warm-up is in progress.
Projection in
progress
Normal operation is in progress.
Cool-down time is approximately 30 seconds.
Cool-down
in
After cool-down is complete, the projector goes to standby mode.
progress
You cannot use the remote control or the projector's control panel
during cool-down.
If the main power switch at the rear of the projector is turned off before
cool-down is complete, wait for the lamp to cool down (normally about
one hour is required) before turning the power back on again.
p.37
p.38
p.39
p.41
, projection will start after a brief interval.
●
p.39
Only part of the image is displayed.
●
The whole image appears purplish or
greenish, images are black & white, colours
appear dull, etc.
(Computer monitors and LCD screens have
different colour reproduction performance, so
that the colours projected by the projector and
the colours appearing on the monitor may not
necessarily match, but this is not a sign of a
problem.)
p.38
●
●
●
p.41
normal
: Lit
: Flashing
p.40
p.40
p.41
Hide quick links:
Advertisement
Chapters
Table of Contents
