Rear; Base - Epson EMP-TW 700 User Manual

Part Names and Functions

Rear

•
[SCART] input port
Connects to the SCART ports of
other video equipment using the
D SCART adaptor that is packed
with the projector.
•
[Trigger out] port
When the projector power
is turned on, a 12 V DC
signal is output from this port.
When the projector's power is
turned off or a problem with
operation occurs, the output
becomes 0 V to send the
projector's power ON/OFF
status to an external device.
•
[Video] input port
Connects to general video ports of
other video equipment.
•
[S-Video] input port
Inputs an S-Video
projector from other video equipment.

Base

•
Suspension bracket fixing points (4 points)
Install the optional ceiling mount here when suspending the projector from a ceiling.
•
8
•
[Component] input port
Connects to the component video
p.12
of other video equipment.
p.12
•
Power inlet
p.12
Connects the power cable.
signal to the
Lamp cover p.44
Open this cover when replacing the lamp
inside.
p.12
(YCbCr or YPbPr ) ports
•
[PC] input port p.12
Connects to the RGB port
of a computer.
•
Main power switch
p.14
p.14
p.46
•
Air filter (air intake vent)
Prevents dust and other foreign particles
from being drawn into the projector.
It should be cleaned periodically.
•
[HDMI ] input port
Connects to video equipment or a
computer that is HDMI-
compatible.
•
Remote control
light-receiving
area
Receives signals
from the remote
control.
•
Security lock
p.53
•
[RS-232C] port
Connects the projector to a computer
using an RS-232C cable. This port is
for control use and should not be used
by the customer.
p.42, 44
p.12
p.13