EchoStar DVR-5000 HDD Viaccess Supplementary Manual page 21

2.2.2. FIXED DISH SETUP - SUB-MENU
This sub-menu allows you to customize the system setup to add an additional fixed dish into
your motorized or DiSEqC1.2 configuration. Note that the menu page is dynamic which
means that it changes with the selections you make. You can customize:
2.2.3. PROGRAM SATELLITES - SUB-MENU
This sub-menu allows you to customize the system setup to add an additional satellite into
your receiver. Note that the menu page is dynamic which means that it changes with the
selections you make. You can customize and view:
EchoStar International Corporation
Familiarization
LNBs
I
To set the amount of LNBs you have installed.
Polarity (DVR-7000 series only)
I
To set the device that controls the signal polarity.
Switch
I
Shows the switch type which you use to control the
dish installation.
LNB1
I
Shows the LNB type which you use on the
motorized dish.
LNB2, LNB3, LNB4
I
To set the LNB type(s) you use on the fixed dish(es).
SAT
I
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
Port
I
To select the switch port for the LNB.
Check signal
I
To confirm the selections you made and advance to
the Check signal page.
SAT
I
To select the satellite you want to scan for the LNB.
Satellite S00 brings you to the add data menu.
Search mode (for digital receivers only)
I
To set a specific search mode (All, FTA, IF, TP,
network or update).
Search mode (for analog/digital receivers only)
I
To set a specific search mode (All, FTA, network, TP,
Digital, Analog, Digital IF, Analog IF or update).
Longitude
I
To view the satellite location on the Clarke Belt.
User LNB
I
Shows the LNB type which you use on the
motorized dish.
Section 4
4
Page 4 - 7