Cisco 520-T1 - Small Business Pro SR Secure Router Software Configuration Manual page 43

Chapter 3 Configuring PPP over Ethernet with NAT
Command
Step 6
exit
Example:
Router(config-if)# exit
Router(config)#
Step 7
interface type number
Example:
Router(config)# interface fastethernet 4
Router(config-if)#
Step 8 ip nat {inside | outside}
Example:
Router(config-if)# ip nat outside
Router(config-if)#
Step 9 no shutdown
Example:
Router(config-if)# no shutdown
Router(config-if)#
Step 10
exit
Example:
Router(config-if)# exit
Router(config)#
Step 11
access-list access-list-number {deny | permit}
source [source-wildcard]
Example:
Router(config)# access-list 1 permit
192.168.1.0 0.0.0.255
If you want to use NAT with a virtual-template interface, you must configure a loopback interface. See
Note
Chapter 1, "Basic Router Configuration,"
For complete information on the NAT commands, see the Cisco IOS Release 12.3 documentation set.
For more general information on NAT concepts, see
OL-14210-01
Purpose
Exits configuration mode for the Fast Ethernet
interface.
Enters configuration mode for the Fast Ethernet
WAN interface (FE4) to be the outside interface
for NAT.
Identifies the specified WAN interface as the NAT
outside interface.
For details about this command and additional
parameters that can be set, as well as information
about enabling static translation, see the
Cisco IOS IP Command Reference, Volume 1 of 4:
Addressing and
Enables the configuration changes just made to the
Ethernet interface.
Exits configuration mode for the Fast Ethernet
interface.
Defines a standard access list indicating which
addresses need translation.
All other addresses are implicitly denied.
Note
for information on configuring a loopback interface.
Appendix B, "Concepts."
Cisco Secure Router 520 Series Software Configuration Guide
Configure Network Address Translation
Services.
3-7