Chapter 1
Basic Router Configuration
Interface Port Labels
Table 1-1
Table 1-1
Router
Cisco Secure Router 520
Ethernet-to-Ethernet routers
Cisco Secure Router 520
ADSL-over-POTS routers
Cisco Secure Router 520
ADSL-over-ISDN routers
Configuring Basic Parameters
To configure the router, perform one or more of these tasks:
•
•
•
•
•
A configuration example is presented with each task to show the network configuration following
completion of that task.
OL-14210-01
Order the appropriate line from your public telephone service provider. Ensure that the ADSL
–
signaling type is DMT (also called ANSI T1.413) or DMT Issue 2.
Once you have collected the appropriate information, you can perform a full configuration on
your router, beginning with the tasks in the
lists the interfaces supported for each router and their associated port labels on the equipment.
Supported Interfaces and Associated Port Labels by Router
Configure Global Parameters
Configure Fast Ethernet LAN Interfaces
Configure WAN Interfaces
Configuring a Loopback Interface
Configuring Command-Line Access to the Router
"Configuring Basic Parameters"
Interface
Fast Ethernet LAN
Fast Ethernet WAN
Wireless LAN
Fast Ethernet LAN
ATM WAN
Wireless LAN
Fast Ethernet LAN
ATM WAN
Wireless LAN
Cisco Secure Router 520 Series Software Configuration Guide
Interface Port Labels
section.
Port Label
FE0–FE3
FE4
None (antenna is not labeled)
LAN (top), FE0–FE3 (bottom)
ADSLoPOTS
None (antenna is not labeled)
LAN (top), FE0–FE3 (bottom)
ADSLoISDN
None (antenna is not labeled)
1-3