Asus RX3141 User Manual page 81

RX3141 User's Manual
System Administration configuration page, as shown in Figure 11.1, allows you to change login password and
other global settings for RX3141. Follow the steps below to change password and/or system-wide settings:
1. Open the System Administration configuration page, as shown in Figure 11.1, by double clicking
the Router Setup
2. Changing login password
a) Type the new password in the New Password text field and again in the Confirm Password
text field. The password can be up to 16 characters long. When logging in, you must type the
new password in the same upper and lower case characters that you enter here.
3. Clone the MAC address for WAN
a) If you had previously registered a specific MAC address with your ISP for Internet access,
enter the registered MAC address here; otherwise, keep the default setting – the factory
assigned MAC address for the WAN port.
4. Auto logout after idle (min): Click "Enable" radio button and enter in-activity time out period to
enable this option; otherwise, click on the "Disable" radio button, or enter 0 in the text field to
diable this option. When this option is enabled, you will be automatically disconnected from the
router when the idle timer expires during system configuration via your browser. You'll have to log
into the RX3141 again if you want to continue system configuration.
5. Enable UPnP service: check or uncheck the check box to enable or disable UpnP service.
6. Enable DNS Proxy: Check or uncheck the check box to enable or disable DNS proxy service.
7. Allow Administration from Interface: check or uncheck the check box to enable or disable remote
management via WAN port.
8. Allow Ping Interface: You may check the LAN and/or WAN check box to allow ping to the RX3141
from the LAN or WAN interface. It is recommended that you enable this option for the LAN only.
9. Click on
Administration menu.
button to save the settings.
Chapter 11. System Management
71