Table of Contents
Advertisement
Chapter 5 Router Connection Setup
5.2.5
Static IP
5.2.5.1
WAN Static IP Configuration Parameters
Table 5.4 describes the configuration parameters available for static IP connection mode.
Setting
Connection Mode
IP Address
Subnet Mask
Gateway Address
Primary/Secondary
DNS Server
5.2.5.2
Configuring Static IP for WAN
Follow the instructions below to configure static IP settings:
1. Open the Router Connection configuration page by double clicking the Router Setup
Connection menu.
2. Select Static from the Connection Mode drop-down list as shown in Figure 5.13.
3. Enter WAN IP address in the IP Address field. This information should be provided by your ISP.
4. Enter Subnet Mask for the WAN. This information should be provided by your ISP. Typically, it is
255.255.255.0.
5. Enter gateway address provided by your ISP in the space provided.
6. Enter the IP address of the primary DNS server. This information should be provided by your ISP.
Secondary DNS server is optional.
7. Click
.
34
Figure 5.13. WAN – Static IP Configuration
Table 5.4. WAN Static IP Configuration Parameters
Description
Select Static from the connection mode drop-down list.
WAN IP address provided by your ISP.
WAN subnet mask provided by your ISP. Typically, it is set as 255.255.255.0.
Gateway IP address provided by your ISP. It must be in the same subnet as
the WAN on the RX3141.
You must at least enter the IP address of the primary DNS server. Secondary
DNS server is optional
to save the settings
RX3141 User's Manual
Connection
Mode drop-
down list
Advertisement
Table of Contents
