Table of Contents
Advertisement
RX3141 User's Manual
5.2.3.2
Configuring PPPoE Unnumbered for WAN
Follow the instructions below to configure PPPoE unnumbered settings:
1. Open the Router Connection configuration page by double clicking the Router Setup
Connection menu.
2. Select PPPoE Unnumbered from the WAN Connection Mode drop-down list as shown in Figure
5.11.
3. Enter user name and password provided by your ISP..
4. (Optional) Enter the service name if required by your ISP.
5. Enter appropriate connection settings for " Disconnect after Idle (min) " and " Connect on
Demand ".
6. Click
5.2.4
Dynamic IP
Dynamic IP is most often used by the cable modem service providers.
Figure 5.12. WAN – Dynamic IP (DHCP client) Configuration
5.2.4.1
Configuring Dynamic IP for WAN
Follow the instructions below to configure dynamic IP settings:
1. Open the Router Connection configuration page by double clicking the Router Setup
2. Select Dynamic from the Connection Mode drop-down list as shown in Figure 5.12. Note that the
IP addresses for the primary and/or the secondary DNS servers are automatically assigned by
the DHCP server of your ISP.
3. Click
to save the settings.
to save the settings.
Chapter 5 Router Connection Setup
Connection
Mode drop-
down list
menu.
33
Advertisement
Table of Contents
