Table of Contents
Advertisement
Chapter 9. Configuring Firewall/NAT Settings
9.6.1
Add a Self-Access Rule
To add a Self-Access rule, follow the instructions below:
1. Open the Self-Access Rule configuration page, as shown in Figure 9.8, by double clicking the
Router Setup
2. Select " Add New " from the " ID " drop-down list.
3. Set desired action (Allow or Deny) from the " Action " drop-down list.
4. Assign a priority for this rule by selecting a number from the " Move to " drop-down list. Note that
the number indicates the priority of the rule with 1 being the highest. Higher priority rules will be
examined prior to the lower priority rules by the firewall.
5. Make desired changes to any or all of the following fields: source/destination IP,
source/destination port, protocol, ICMP message type and log. Please see Table 9.3 for
explanation of these fields.
6. Click on the
displayed in the Existing Self-Access ACL list table at the bottom half of the Self-Access ACL
configuration page.
Example
Figure 9.9 shows a sample self-access ACL configuration to allow TCP port 80 traffic (i.e. HTTP traffic) from
any one to RX3141.
9.6.2
Modify a Self-Access Rule
To modify a Self-Access rule, follow the instructions below:
1. Open the Self-Access Rule configuration page, as shown in Figure 9.8, by double clicking the
Router Setup
2. Click on the
or select the Self-Access ACL from the ID drop-down list.
60
Figure 9.8. Self-Access ACL Configuration Page
Self Access ACL menu.
button to create the new Self-Access rule. The new rule will then be
Figure 9.9. Self-Access ACL Configuration Example
Self Access ACL menu.
icon of the Self-Access rule to be modified in the Existing Self-Access ACL table
RX3141 User's Manual
Advertisement
Table of Contents
