Installation; Wired Connection; Starting The Setup Wizard - TRENDnet TV-IP572P User Manual

TRENDnet User's Guide

Installation

Wired Connection

1. Connect the Ethernet Cable
If you intend to use the network camera as a wired device, connect one end of
the included Ethernet cable into the Ethernet port on the rear panel of the
camera and connect the other end to an available port on your network. If you
prefer to use the camera on a wireless network, see below for instructions on
connecting the power adapter.
2. Attach the Power Supply
Attach the included power supply to the DC 5V 1.2A receptor on the rear panel
of the camera and then connect it to a wall outlet or power strip. A blue LED
will light up under the lens indicating that the camera has power.
© Copyright 2012 TRENDnet. All Rights Reserved.

Starting the Setup Wizard

Insert the included CD-ROM into your CD/DVD drive. The Install Wizard program will run
automatically.
Note: If the Install Wizard does not run, you may have autorun disabled on your
machine. In this case, browse to the CD drive and run InstallWizard.exe to begin the
installation wizard.
Begin by selecting Setup Wizard and follow the on-screen steps to continue the
installation.
When the installation of the Setup Wizard is complete, run the Setup Wizard:
1. Click Start > Programs > TRENDnet > SetupWizard > SetupWizard. The
TRENDnet Setup Wizard appears.
TV-IP572P / TV-IP572PI
5