TRENDnet TV-IP110 User Manual page 53


Factory Reset
Click Reset to restore all factory default settings for the camera.

System Reboot
Click Reboot to restart the camera just like turning the device off and
on. The camera configuration will be retained after rebooting.

Configuration
You can save your camera configuration as a backup file on your
computer. Whenever you want to resume the original settings, you can
restore them by retrieving the backup file.
- Backup: Click Get the backup file to save the current configuration
of the camera.
- Restore: Click Browse to locate the backup file and then click
Restore.

Update Firmware
This item displays the current firmware version. You can upgrade the
firmware for your camera once you obtained a latest version of
firmware.
- Select the firmware: Click Browse to locate the backup file
(xxx.pck) and then click Update. Factory reset and IP Setup are
required after firmware update.
NOTE Make sure to keep the camera connected to the power source during
the process of upgrading firmware. Otherwise, the camera might be
damaged because of failure of upgrading firmware.
- 52 -