Add Adapters In The Utility And Create A Customized Encryption Key - TRENDnet TPL-306E User Manual

TRENDnet User's Guide

Add adapters in the utility and create a customized encryption key

If you have not written down the Device Password (DPW) and MAC address for each of
your Powerline adapters, please do so as it is required to applying the customized
encryption key for all of your Powerline adapters using the utility.
Note: Write down the Device Password (DPW) (16-digit characters A-Z only) and
MAC Address (12-digit characters a-f,A-F,0-9) of each Powerline adapter first
Example:
Location of Powerline Adapter Device Password (DPW)
To Router ZAYB-VIMV-YFAQ-ZFPA
John's Room WECC-ZZYC-WJVY-GZRS
Jane 's Room UXMA-UOUP-IQXJ-UTYN
Note: It is recommended to ensure that your Powerline adapters are already installed
and connected and the Ethernet port on each adapter is connected to a device powered
on.
First, add all of the Powerline adapters to the utility and enter the Device Password
(DPW) for each Powerline adapter to ensure you can change the encryption key for
multiple adapters. This is required when using the Powerline utility to change the
encryption key for multiple Powerline adapters.
To add automatically detected Powerline adapters to the Powerline Utility
1. Launch the Powerline Utility.
© Copyright 2012 TRENDnet. All Rights Reserved.
before proceeding.
MAC Address
00:90:47:15:84:89
00:90:47:15:84:88
00:90:47:1F:1A:85
2. In the Powerline Utility Main window, wait for the utility to automatically scan for
Powerline adapters already connected to your Powerline network. If your Powerline
adapters have already been installed and connected using the same encryption key,
they should appear in the Remote Device list.
3. Select one of the Powerline adapters listed under Remote Device.
4. Click Enter Password.
TPL-306E / TPL-306E2K
18