TQ TQMa95xxSA Quick Start Manual

Quick-Start-Guide STKa95xxSA
1
CONNECT HOST PC AND STKa95xxSA
1
Use the supplied USB cable (USB2.0 ST-A / Micro-B) to connect Debug USB (X20)
of the STKa95xxSA to a USB port of your host PC.
RUN TERMINAL EMULATOR AND CONFIGURE SERIAL PORT
Run your preferred terminal emulator on the host PC (we recommend Tera Term
Pro) and configure the serial port.
SUPPLY THE STK WITH POWER
2
Double-check the main voltage required for the included Power supply, then connect it to connector
X12 on the MB-SMARC-2. Caution when using a different power supply! The Starterkit can be operated
using a regulated supply voltage of 14-36V
ESTABLISH SERIAL CONNECTION
The boot messages of boot loader and operating system are displayed by the terminal emulator.
When the kit has fully booted you can log in to the system with the username
!
For latest documentation, BSPs, etc. please visit:
tq-group.com/en/products/tq-embedded/arm-architecture/tqma95xxsa/
support.tq-group.com/TQMa95xxSA
© TQ-Systems GmbH 2024 | All data is for information purposes only | Subject to change without notice | EMB_QSG_STKa95xxSA_Rev0001
2
Baudrate
Data bits
Parity
Stop bits
Handshake XON/XOFF
root .
115200
8
none
1