TQ STKa93 CA Series Quick Start Manual

Quick-Start-Guide STKa93xxCA
Arm® architecture
1

CONNECT HOST PC AND STKNAME

1
Use the supplied USB cable (USB2.0 ST-A / Micro-B) to connect Debug USB (X22)
of the STKa93xxCA to a USB port of your host PC.

RUN TERMINAL EMULATOR AND CONFIGURE SERIAL PORT

Run your favourite terminal emulator on the host PC (we recommend Tera Term
Pro) and configure the serial port.

SUPPLY THE STK WITH POWER

2
Double-check the mains voltage required for the included Power supply, then connect it to connector
X23 on the MBa9xxxCA. Caution when using a different power supply! The Starterkit Can be operated
using a regulated supply voltage of 16-30V (nom. 24V)!

ESTABLISH SERIAL CONNECTION

The boot messages of boot loader and operating system are displayed by the terminal emulator.
When the kit has fully booted you can log in to the system with the username
!
For latest documentation, BSPs, etc. please visit:
tq-group.com/en/products/tq-embedded/arm-architecture/stka93xx/
support.tq-group.com/TQMa93xxCA
© TQ-Systems GmbH 2023 | All data is for information purposes only | Subject to change without notice | EMB_QSG_STKa93xxCA_Rev0001
2
Baudrate
Data bits
Parity
Stop bits
Handshake XON/XOFF
root
.
115200
8
none
1