TQ Arm STKa67 Series Quick Installation Manual

Quick-Start-Guide STKa67xx
Arm® architecture
CONNECT HOST PC AND STKNAME
1
Use the supplied USB cable (USB2.0 ST-A / Micro-B) to connect Debug USB (X7) of
the STKa67xx to a USB port of your host PC.
RUN TERMINAL EMULATOR AND CONFIGURE SERIAL PORT
Run your favourite terminal emulator on the host PC (we recommend Tera Term
Pro) and configure the serial port.
SUPPLY THE STK WITH POWER
2
Double-check the mains voltage required for the included Power supply, then connect it to connector
X5 on the MBa67xx. Caution when using a different power supply! The Starterkit Can be operated using
a regulated supply voltage of 16-30V (nom. 18V)!
ESTABLISH SERIAL CONNECTION
The boot messages of boot loader and operating system are displayed by the terminal emulator.
When the kit has fully booted you can log in to the system with the username
!
For latest documentation, BSPs, etc. please visit:
tq-group.com/en/products/tq-embedded/arm-architecture/STKa67xx
support.tq-group.com/TQMa67xx
1
© TQ-Systems GmbH 2025 | All data is for information purposes only | Subject to change without notice | EMB_QSG_STKa67xx_Rev0001
2
Baudrate
Data bits
Parity
Stop bits
Handshake XON/XOFF
root
.
115200
8
none
1