BFT CLONIX1 Installation And User Manual page 5

BASIC PROGRAMMING OF CLONIX 2
GB
Impulsive output 1 and 2 (to activate, for example, a control
unit and its pedestrian opening)
1
Press the key SW1 once.
4
Press the key T1, LED will flash quickly to indicate that it has been memorized
successfully. Flashing as normal will then be resumed.
7
The led begins to flash.
9
Press the key T2, LED will flash quickly to indicate that it has been memorized
successfully. Flashing as normal will then be resumed.
Fig. 1
T1 T2
41
Fig. 2
2
The led begins to flash.
Press the hidden key until the led of the receiver stays on.
T1 T2
T4 T3
41
3
Press the hidden key until the led of the receiver stays on.
5
Wait for the led to switch off.
8
10
Wait for the led to switch off.
6
Press the SW2 once.
CLONIX/MITTO - Ver. 06 - 23