Related Manuals for TRENDnet TEW-P1P
Summary of Contents for TRENDnet TEW-P1P
- Page 1 Page 1 Page 2...
- Page 2 TEW-P1P/TEW-P1U Quick Installation Guide 2. Wireless Network Environments 1. Print Server Layout Infrastructure (AP) Mode TEW-P1P TEW-P1U (IEEE 1284 Parallel Connector) (USB Connector) Back Side 1. Reset Button 2. Status LED (Orange) 3. WLAN LED (Green) 4. DIP Switch Nor- Normal Mode (Infrastructure) Diag-Diagnostics Mode (Ad-hoc) Ad-hoc (Peer-to-Peer) Mode 5.
-
Page 3: Hardware Installation
3. Hardware Installation Infrastructure Mode: Switch the Print Server’s DIP switch to DIAG mode. Power off the Print Server and Printer. Check on the Computer’s and see if TCP/IP protocol (for the wireless Connect the Print Server’s printer port (USB or Parallel) to the printer. adapter) is installed and an IP address assigned to the wireless Plug the AC power adapter into the power connector on the back of the adapter. - Page 4 Choose Install Setup Utility, the program will automatically install the Click NEXT, the wizard will automatically discover the wireless print server, Setup Wizard into your computer. if it can not be found, try rescan. After the installation completes, the Setup Wizard window would appear, The Print Server will appear in the list, select the print server you want to Click on Wireless Setup Wizard to configure Wireless settings.
- Page 5 Select YES if you want to change the configuration and press NEXT to Choose Enable the WEP Encryption as you need, and click NEXT. continue. The default value is Disabled. 10. Specify a fixed IP address or use dynamic IP address, then click NEXT. Configure the Wireless Settings here to match your Network environment Note: For TCP/IP printing environment, fix IP address is recommended.
-
Page 6: Printer Installation
Printer Installation 11. In this page, you can confirm your settings again. Click NEXT. Go back to Setup Wizard and select Network Print Server Setup 12. Wireless Configurations Complete. Click the Network Print Server Setup Wizard and the following window appears. Page 9 Page 10... - Page 7 Click Next and the program will discover your wireless print server. Click Next and choose the printer you want to install. Select the print server which you want to configure and press NEXT. If the printer is not listed under Printer Name, click on Add New Printer and follow the below instruction.
-
Page 8: Technical Support
Click Next and setup program will display the summary of your Diagnostic printer’s configuration. If you don’t have an Access Point in your network or the print server cannot be discovered in Infrastructure Mode, please refer to the following steps Switch the Print Server’s DIP switch to DIAG mode. - Page 9 Page 15 Page 16...