Requirements; Procedure - TRENDnet TEW-431BRP User Manual

Rear Panel
Figure 3: Rear Panel
Power port Connect the supplied power adapter here.
10/100BaseT Use standard LAN cables (RJ45 connectors) to connect your PCs to
these ports.
LAN connections
If required, any port can be connected to another hub. Any LAN port
will automatically function as an "Uplink" port when necessary.
Connect the DSL or Cable Modem here. If your modem came with a
WAN port
(10/100BaseT) cable, use the supplied cable. Otherwise, use a standard LAN cable.
This button has two (2) functions:
Reset Button
•
Reboot. When pressed and released, the TEW-431BRP will
reboot (restart).
•
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
To Clear All Data and restore the factory default values:
1. Power Off.
2. Hold the Reset Button down while you Power On.
3. Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
4. Release the Reset Button. The TEW-431BRP is now using the
factory default values.
Introduction
5
Chapter 2
Installation
This Chapter covers the physical installation of the TEW-431BRP.

Requirements

•
Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
•
TCP/IP protocol must be installed on all PCs.
•
For Internet Access, an Internet Access account with an ISP, and either of a DSL or Cable
modem (for WAN port usage)
•
To use the Wireless Access Point, all Wireless devices must be compliant with the
IEEE802.11g specifications.

Procedure

Figure 4: Installation Diagram
1. Choose an Installation Site
Select a suitable place on the network to install the TEW-431BRP.
Ensure the TEW-431BRP and the DSL/Cable modem are powered OFF.
2
6