Table of Contents
Advertisement
3. Connecting with your devices
Before connecting them, make sure that the devices are suitable to connect with this
projector, and prepare the required signal cables and adapters. Consult your dealer if
the accessory that is not included in this product is required. Refer to the following for
connection. If you want to use the cable cover, see the paragraph " 6. Using the cable
cover " ( 6) beforehand.
USB-A
Monitor
WARNING
■ Use only the accessories contained in this product or recommended by your dealer. Do
not modify the projector or accessories.
■ For the cable with a ferrite core only at one end, connect the end with the core to
the projector. The cables may be required a specific length or a ferrite core by the
regulations.
■ Be careful not to damage the cables. Route the cables so that they are not likely to be
walked on or pinched by items placed upon or against them.
CAUTION
■ Do not connect or disconnect the projector with devices while they are connected to a
power supply, except for the cases directed by the manuals.
■ Be careful not to set a connector into a wrong port or with a wrong way.
4
RS-232C
RGB OUT
RGB IN
MONITOR OUT
CONTROL
Y
C
/P
C
/P
B
B
R
R
L
R
COMPONENT VIDEO OUT
AUDO OUT
PCs
AUDIO
AUDIO
RGB OUT
OUT
OUT
COMPUTER IN2
COMPUTER IN1
LAN
1
AUDIO
USB
S-VIDEO
OUT
2
AUDIO IN
Y
C
/P
C
/P
B
B
R
R
VIDEO
L
R
AUDIO IN3
VIDEO
L
R
L
S-VIDEO
OUT
AUDO OUT
AUDO OUT
OUT
LAN
AUDIO IN
Speakers
(with an amplifier)
VCR/DVD
players
R
Advertisement
Table of Contents
