Denon AVR-990 Owner's Manual page 40

ENGLISH
Making Detailed Settings (Manual Setup)
Setting items
EQ Customize Audyssey Flat : Set when not using the "Audyssey Flat" equalizer.
• Used : Use.
(Continued)
• Not Used : Do not use.
Set so that "Audyssey Flat" settings can be made when Audyssey™
Auto Setup procedure is performed.
Manual : Set when not using the "Manual" equalizer.
• Used : Use.
• Not Used : Do not use.
Making the Network Settings (Network Setup)
Make network settings.
Setting items
Network Connecting 1. Connect the LAN cable (vpage 22 "Connecting to a Home Network
(LAN)").
Make settings for wired
LAN. 2. Turn on the AVR-990 (vpage 23 "Turning the Power On").
AVR-990 performs automatic network setup due to the DHCP function.
When connecting to a network that has no DHCP function, perform the
setting in step 3.
3. Set the IP address at the "Network Connecting".

Remote control operation
buttons
Setting contents
Default settings are underlined.
Setting contents
w
r
q
:Displaying the menu :Moves the cursor
Cancel the menu (Up/Down/Left/Right)
Setting items
Network Connecting
(Continued)
b
•
•
e
•
•
•
:Confirm the setting
Setting contents
q On the GUI menu, select "Network Connecting" – "Detail" and
ENTER
press .
w Use o p to set "DHCP" to "OFF", then press
The DHCP function is disabled.
e Use uip to input the address and press
• IP Address : Set the IP address within the ranges shown below.
The Network Audio function cannot be used if other IP addresses
are set.
CLASS A: 10.0.0.0 ~ 10.255.255.255
CLASS B: 172.16.0.0 ~ 172.31.255.255
CLASS C: 192.168.0.0 ~ 192.168.255.255
• Subnet Mask : When connecting an xDSL modem or terminal
adapter directly to the AVR-990, input the subnet mask indicated
in the documentation supplied by your provider. Normally input
255.255.255.0.
• Default Gateway : When connected to a gateway (router), input
its IP address.
• Primary DNS, Secondary DNS : If there is only one DNS address
indicated in the documentation supplied by your provider, input it
at "Primary DNS". If there are two or more DNS addresses, input
the first one at "Secondary DNS".
ENTER
r Use i to select "Exit" and press
Setup is complete.
When connecting to the network via a Proxy server, select "Proxy" and
ENTER
press (vpage 38 "Proxy settings").
If you are using a broadband router (DHCP function), there is no need
to make the settings at "IP Address" and "Proxy", since the DHCP
function is set to "ON" in the AVR-990's default settings.
If the AVR-990 is being used connected to a network without the
DHCP function, the network settings must be made. In this case, some
knowledge of networks is required. For details, consult a network
administrator.
If you cannot connect to the Internet, recheck the connections and
settings (vpage 22).
If you do not understand about Internet connection, contact your ISP
(Internet Service Provider) or the store from which you purchased your
computer.
When you want to cancel the setting during IP address input, press
RETURN
.
:Return to previous menu
i .
ENTER
.
.