External Controller; Connecting The Power Cord; Once Connections Are Completed; Turning The Power On - Denon AVR-1609 Owner's Manual

n AM loop antenna assembly
Connect to the AM
antenna terminals.
Remove the vinyl tie and take
out the connection line.
a. With the antenna on top of
any stable surface.
Mount
Installation hole Mount on wall, etc.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.

External Controller

Connecting a Room-to-Room Remote Control Unit
Input
Infrared
retransmitter
Bend in the reverse direction.
b. With the antenna attached
to a wall.
Extension jack for future use.
Output
(Connect devices corresponding
Infrared
with room to room function to
sensor
this jack.)

Connecting the Power Cord

Wait until all connections have been completed before connecting the power cord.
NOTE
• Insert the AC plugs securely. Incomplete connections could cause noise.
• Only use the AC outlets to plug in audio equipment. Do not use them as power supplies for hairdryers or
anything other than audio equipment.

Once Connections are Completed

Turning the Power On

(vpage 37)
To household
Power cord
power outlet
(AC 120 V, 60 Hz)
Connection to the AC outlets
• These outlets supply power to external audio
equipment.
• The power supplied from these outlets turns on and
off together with the set's power switch.
• Audio equipment with a total power consumption
of 120 W (1 A) can be connected.
ENGLISH