Auto Surround Mode; Direct Mode Setup; A0 Remote Id Setup - Denon AVR-1609 Owner's Manual

h ZONE2 Power On Level
This sets the volume set when the ZONE2's power is turned on.
[Selectable items]
Last
: Use the memorized setting from the last session.
– – –
: Always use the muting on condition when power
is turned on.
[Variable range]
–70dB ~ +18dB
: Set the volume level when the power is turned on
in units of 1 dB.
b The variable level when upper limit has been set with "Volume
Limit" is "–70 dB ~ the set volume level" .
j ZONE2 Mute Level
This sets the amount of attenuation of the volume when the mute
mode is set in the ZONE2.
[Selectable items]
Full
: The sound is cut off entirely.
–40dB
: The sound is attenuated by 40 dB.
–20dB
: The sound is attenuated by 20 dB.
"ZONE2 Volume Control" is displayed when "ZONE2" is selected
with "Amp Assign" (vpage 27).
k Auto Surround Mode
Make setting for memorizing surround mode setting for each input
signal type.
[Display]
1 . S p 2 . I n 3 . O p
O p t i o n S e t u p
8 A u t o S u r r . : O N
[Selectable items]
ON
: Memorize settings. Most recently stored surround mode is
automatically selected.
OFF
: Do not memorize settings. Surround mode does not change
according to input signal.
The auto surround mode function lets you store in the memory the
surround mode last used for playing the three types of input signals
listed below.
q Analog and PCM 2-channel signals (STEREO)
w 2-channel signals of Dolby Digital, DTS or other multi-channel
format (DOLBY PLgx Cinema)
e Multi-channel signals of Dolby Digital, DTS or other multichannel
format (DOLBY/DTS SURROUND)
b Default settings are indicated in ( ).
For details on how to select, set and cancel settings for each menu, see "System setup operation" (vpage 21).
l Direct Mode Setup
Select MultEQ use for DIRECT mode playback.
[Display]
1 . S p 2 . I n
E O p t i o n S e t u p
E
[Selectable items]
ON
: Use MultEQ.
OFF
: Do not use MultEQ.
A0 Remote ID Setup
Set remote control ID.
[Display]
1 . S p 2 . I n
O p t i o n S e t u p
[Selectable items]
NOTE
When using the AVR-1609 with only the included remote control unit
(RC-1098), there is no need to make settings.
When using a separately sold remote control unit (RC-7000CI, etc.),
this function can be used. Match the ID setting of the remote control
unit and the receiver.
ENGLISH
3 . O p
E
E
9 D i r e c t : O F F
3 . O p
E
E
1 0 R e m o t e I D : 1
1 2 3 4