Using Remote Install Software - Dell PowerEdge 1655MC System Configuration Manual

Select the Mirroring Properties Menu.
3
Press <Enter> to view or modify the mirroring.
4
NOTE: Two drives must be installed to enable integrated mirroring.
The two installed SCSI drives are listed with their SCSI IDs.
Select the primary drive.
5
Ensure that the Mirrored Pair field is set to Primary.
6
Select the remaining drive.
7
Ensure that the Mirror Pair field for the remaining drive is set to Secondary.
8
The drive that is set to secondary will mirror the primary drive. All other data on the
secondary drive will be lost.
Press <Esc> to exit the Adapter Properties Menu.
9
Select Save changes and exit this menu and press <Enter>.
10
Press <Esc> to exit the Main Menu.
11
Select Exit the Configuration Utility and press <Enter>.
12
The server module reboots and shows mirrored status after POST.
For additional information on integrated mirroring, see the Dell PowerEdge RAID Controller
4/im Integrated Mirroring Guide.

Using Remote Install Software

Remote Install software uses Preboot Execution Environment (PXE) to deploy images to
server modules over the network. Remote Install uses a management station/deployment
server including an image database and management agents to deploy images to server
modules.
You can use Remote Install software to capture, predeploy, deploy, and configure systems.
• Capture — Allows you to capture an image for deployment to other servers or to
capture an image for backup. Capturing for deployment removes the unique
configuration of that system so the image can be can be deployed to other systems.
Capturing for backup captures an exact copy of the system's configuration, which can
be redeployed in the event of failure.
System Configuration Guide
1-23