Table of Contents
Advertisement
DWL-G520M User's Manual
Using the Configuration Utility
Configuration
SSID (1-3):
The Service Set Identifier is the name assigned to the wireless
network. The factory SSID setting is default. You can enter up to 3
wireless networks to connect to.
Wireless Mode:
Select Infrastructure if you want to connect to an access point or
wireless router. Ad-Hoc mode is used for peer-to-peer networking.
Channel:
The channel selection is automatically determined by the
DWL-G520M. When in Ad-Hoc mode, you may select a channel
manually. The default channel is 6.
Ad-Hoc Band:
Select 11G or 11B (see Support Band below).
Power Mode:
Continuous Access Mode is the default setting. For best results leave
this setting at the default.
Support Band:
Select the wireless mode of your wireless network.
11G - Connect to an 802.11g only network.
11B - Connect to an 802.11b only network.
Check both to connect to an 802.11b/g mixed network.
14
D-Link Systems, Inc.
Advertisement
Table of Contents
