Configure Wep - D-Link DIR-451 User Manual

Secton 4 - Securty
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1..Log into the web-based configuration by opening a web browser and entering the IP address of the router (192.168.0.1).
Click on.Wireless.Settings on the left side.
2. Next to Security Mode, select Enable WEP.Security.
3. Next to Authentication, select Open or Shared.Key.
4. Select either 64-bit or 128-bit encryption from the drop-down
menu next to WEP Encryption.
5. Next to Key Type, select either Hex or ASCII.
Hex (recommended) - Letters A-F and numbers 0-9 are valid.
ASCII - All numbers and letters are valid.
6. Next to Key 1, enter a WEP key that you create. Make sure
you enter this key exactly on all your wireless devices. You
may enter up to 4 different keys.
7. Click Save.Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose
connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the router.
D-Lnk DIR-451 User Manual

Configure WEP

4