Administrator Settings - D-Link EBR-2310 User Manual

Section 3 - Configuration
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management.
There are two accounts that can access the management interface through the web browser. The accounts are admin
and user. Admin has read/write access while user has read-only access. User can only view the settings but cannot
make any changes. Only the admin account has the ability to change both admin and user account passwords.
Administrator Enter the new password for the Administrator
Password: login. The administrator can make changes to
the settings.
User Password: Enter the new password for the User login. If you
login as the User, you can only see the settings,
but cannot change them.
Remote Remote management allows the WBR-1310
Management: to be configured from the Internet by a web
browser. A username and password is still
required to access the Web-Management
interface. In general, only a member of your
network can browse the built-in web pages to
perform Administrator tasks.This feature enables
you to perform Administrator tasks from the
remote (Internet) host.
IP Address: The Internet IP address of the computer that has
access to the Broadband Router. If you input an
asterisk (*) into this field, then any computer will
be able to access the Router. Putting an asterisk
(*) into this field would present a security risk
and is not recommended.
Port:
The port number used to access the WBR-1310.
Example: http://x.x.x.x:8080 whereas x.x.x.x is the WAN IP address of the WBR-1310 and 8080 is the port used for the
Web-Management interface.
D-Link EBR-2310 User Manual

Administrator Settings

29