While Playing - Aiwa AM-NX1 Operating Instructions Manual

Symptom
The battery
charging stand and
the recorder become
hot during the
charging procedure.

While playing

Symptom
An MD is not
played normally.
An MD is not
played from the
first track.
Playback sound
skips.
Sound has a lot of
static.
Volume cannot be
turned up.
No sound comes
through the
headphones/
earphones.
36
Cause/Solution
• This is normal and poses no danger.
Cause/Remedy
• Repeat play is selected.
, Press P MODE/
normal play (page 18).
• Playback mode is changed.
, Press P MODE/
normal play (page 18).
• Disc playing stopped before it came to the last track.
, Press NX/ENTER for 2 seconds or more to start playing.
• The disc information has been stored to the Playback Information
Memory.
, Erase the disc information from the Playback Information
Memory (page 28).
• The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a short track.
• Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
• EAR GUARD is on.
, Release EAR GUARD settings (page 27).
• The "USER" on "SOUND" settings are being applied.
, This is not malfuntion. When this setting is applied, the
maximum volume setting will be limited to a certain level to
prevent excessive loudness.
• The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i.
• The plug is dirty.
, Clean the plug.
for 2 seconds or more to change back to the
for 2 seconds or more to change back to the