Connecting The Net Md To Your Computer - Aiwa AM-NX1 Operating Instructions Manual

Connecting the Net MD to your computer

After the software installation is completed, connect the Net MD to your computer.
Refer to the operating instructions of the Net MD as well.
1
Insert a recordable disc into the Net MD.
2
Make the power source and the dedicated USB cable connections with the Net
MD and the computer.
AC
power
adaptor
* If a cradle is supplied with your Net MD, connect the dedicated USB cable to the
USB cradle and place the Net MD onto the USB cradle.
3
Check the connections.
When the connections have been properly made, "PCppMD"* appears in the display
of the Net MD.
* Depending on the device, "Net MD" or "PC>>MD" may be displayed.
Notes
• When using the Net MD connected to your computer, make sure to run the recorder from an AC
outlet. We do not assure the results should there be a mis-operation, check-out failure, or destruction
of audio data caused by insufficient battery power.
• Place the recorder on a stable surface so that the dedicated USB cable does not become detached.
To the USB jack/
dedicated jack
Net MD
devices*
To the DC IN
jack
To the USB
connecting
terminal
Dedicated
USB cable
Computer
49