Messages - Aiwa AM-NX1 Operating Instructions Manual

Messages

If the following error messages flash in the display window on the remote control, check
the chart below.
Error message Meaning/Remedy
BLANKDISC
CannotCHG
Charging
EAR GUARD
ERROR
Hi DC in
LOW BATT
NO DISC
No Entry!
READ ERR
SLOW CHG
TEMP OVER
TOC ERR
TR FULL
• An MD with no recording on it is inserted.
• You tried to charge the battery at a place with a temperature outside
the specified range for the recorder.
, Charge the battery at a temperature of +5 C (+41 F) to +40 C
(+104 F).
• The rechargeable battery is being charged.
• EAR GUARD is set to "EAR G.ON" and so the volume cannot rise
higher.
, Set EAR GUARD to "EAR G. OFF" (page 27).
• There is an internal malfunction in the system.
, Restart the operation by doing steps 1 to 3 on page 38. If the
message appears again, please consult your nearest Aiwa dealer.
• Voltage of the power supply is too high (The supplied AC power
adaptor or the recommended car battery cord is not used).
, Use the supplied AC power adaptor or the recommended car
battery cord.
• Batteries are weak.
, Charge the rechargeable battery or replace the dry battery
(page 13).
• You tried to play or record with no disc in the recorder.
, Insert an MD.
• You tried to erase a setting in the Playback Information Memory on
a disc that contains no settings in the Playback Information Memory
(page 28).
• The recorder cannot read the disc information correctly.
, Reinsert the disc.
• You tried to charge at a place where the temperature is too low.
, Charge the battery at a temperature of +5°C (+41°F) to +40°C
(+104°F).
• Heat has built up in the recorder.
, Let the recorder cool down.
• The recorder cannot read the disc information correctly.
, Insert another disc.
• Track number 254 has been reached.
39