HUST Automation H4CL-T Series Manual page 40

HUSTCNC-H4CL-T Manual
Third block:
(Note that the sign
Fourth block:
Fifth block:
If the size of a program exceeds one page, use ↑ or ↓to check the program on
each page for correctness.
2.2.2.2. Editing a Program
We have created PROGRAM 1 in the previous section. The existing program
change is described in this section. Changing a program includes the following
procedure:
Add (or Change) a Command
Ex: The third block program N3 U480. W-480.
Changed to
Procedure:
1. Make sure the system is in "EDIT" mode.
2. Use ↑/↓ to move to the cursor to block N3.
3. Enter a command code and value to be added (changed), e.g. F0.2.
F
G 0
Insert
U 4
－
W
－
can be entered before the
G 4
X 1
M 9
N3 U480. W-480. F0.2
0 2
Enter
8 0
Enter
4 8 0
Enter
Enter
9
Insert
2 - 32
Enter
key is pressed.)
Enter