Tennant 9014994 Installation Instructions Manual

INSTRUCTION BULLETIN
NOTE: DO NOT DISCARD the Parts List from the Instruction Bulletin. Place the
Parts List in the appropriate place in the machine manual for future
reference. Retaining the Parts List will make it easier to reorder
individual parts and will save the cost of ordering an entire kit.
NOTE: Numbers in parenthesis ( ) are reference numbers for parts listed in Bill of Materials.
Installation instructions for kit number 9014994
SYNOPSIS:
This kit contains the parts needed to replace the main wire harness on T17 scrubbers.
Please follow step-by-step instructions.
SPECIAL TOOLS / CONSIDERATIONS: NONE
(Estimated time to complete: 16- 32 hours)
PREPARATION:
1. Completely empty both the solution tank and
the recovery tank.
2. Drive machine a short distance and turn
steering wheel so front wheel is pointing
straight out from the front of the machine.
Completely lower the scrub head. Turn off the
machine, set the parking brake, and remove
the key.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, set parking brake, and remove key.
3. Disconnect the battery cable from the
machine.
WARNING: Always disconnect battery
cables from machine before working on
electrical components.
IB 9015177 (12- 2017)
PROTECT THE ENVIRONMENT
Please dispose of packaging materials, used machine components
such as batteries and fluids in an environmentally safe way according
to local waste disposal regulations.
Always remember to recycle.
4. Remove the battery from the machine.
FOR SAFETY: When servicing the machine,
avoid contact with battery acid, keep all metal
objects off batteries, use a non- conductive
battery removal device, use a hoist and
adequate assistance when lifting batteries,
battery installation must be done by trained
personnel, follow site safety guidelines
concerning battery removal.
INSTALLATION:
1. Remove the access panel from the steering
channel. Set the access panel and hardware
aside.
2. Disconnect the main wire harness from the
pod assembly and pull the pod assembly out
from the steering assembly. Set the pod
assembly aside.
No. 9015177
Machine: T17
Published: 12- 2017
Rev. 00
1