Advertisement
Quick Links
Installation Instructions for Fountain Basins
Thank you for purchasing an EasyPro Eco-Series Fountain Basin. Following are
a few simple instructions to help you during the installation process.
STEP ONE - LOCATION
Select your location and mark the outline of the basin, avoid low spots. You will want to position the
basin an inch or two higher than the surrounding ground to prevent run off.
STEP TWO - EXCAVATION AND PLACEMENT
Always check for buried utilities before digging. Ex-
cavate approximately 7 - 8 inches. Put a thin layer of
sand down as a base, especially if the soil is rough.
Place basin in excavated hole, making sure it is level
in all directions. Backfi ll all sides with sand or fi ne
soil and fi ll in all voids.
Advertisement
Related Manuals for EasyPro Eco Series
Summary of Contents for EasyPro Eco Series
- Page 1 Installation Instructions for Fountain Basins Thank you for purchasing an EasyPro Eco-Series Fountain Basin. Following are a few simple instructions to help you during the installation process. STEP ONE - LOCATION Select your location and mark the outline of the basin, avoid low spots. You will want to position the basin an inch or two higher than the surrounding ground to prevent run off.
- Page 2 Leave extra tubing for easy pump maintenance. Connect tubing to pump and place in bay. We suggest using 250 - 700 GPH EasyPro mag drive pumps because they are durable and energy effi cient. Place lid over pump compartment. Spread decorative gravel or river rock on grating, just enough to cover grating is all that is required.
Need help?
Do you have a question about the Eco Series and is the answer not in the manual?
Questions and answers