EasyPro Tranquil Décor HBB39 Installation Instructions

HBB39 Bamboo Fountain Tubing and Spout Installation
Thank you for your purchase of the Tranquil Décor
Bamboo Basalt Fountain from EasyPro. Please read
through all instructions before beginning assembly
of your fountain.
HBB39 Bamboo fountain includes
Vertical basalt column
Lower polished stone
Complete kits will include these items as well as
basin, plumbing kit and pump.
Tubing Installation Instructions
1
To connect plumbing to the basalt, lay the
basalt on its side. Be sure to be careful when
moving the basalt. Use assistance if needed to
avoid injury.
2
The bottom hole needs to be sealed by tubing
or other method so water will travel up the
column and out the side port and bamboo
spout. An EasyPro plumbing kit part # PK1L
includes 3/4" tubing and a friction ring that will
seal this hole.
3
With the PK1L tubing kit, install the friction ring
over the end of the tubing.
by
Faux bamboo spout
Tube of black silicone
4
4A
5
Carefully press the assembled friction ring (4A)
and tubing into the bottom hole of the basalt.
It will be a very tight fit. The use of a dull object
(i.e. unsharpened pencil) can be used to help
press the friction ring into the hole. (4B)
Press until friction ring is below the surface of
the basalt. (4C) Avoid breaking or tearing the
friction ring or water will not travel properly up
the column.
friction ring
4B
Once tubing is connected, the column can be
tipped into place on the basin and connected to
the pump.
4C