Table of Contents
Advertisement
3.4.5 SNMP
Configure the router to allow administrative computers to control it through SNMP(Simple
Network Management Protocol).
Parameter
Enable SNMP
Get Community
Set Community
IP 1~4
SNMP Version
Click Save after you've finished all settings.
Description
You must check either Local or Remote or both to enable SNMP
function. If Local is checked, this device will respond to requests
from LAN. If Remote is checked, this device will respond to
requests from WAN.
Setting the community of GetRequest your device will respond to.
Setting the community of SetRequest your device will accept.
Input your SNMP Management PC's IP here. User has to
configure where this device should send SNMP Trap message to.
Please select proper SNMP Version that your SNMP
Management software supports.
80
Advertisement
Table of Contents
