Operation - Zephyr ESSENTIALS Roma Island ZRM-E36AS Instructions For The Use, Care And Installation

WARNING
TO REDUCE THE RISK O F FIRE, USE ONLY M ETAL DUCTWORK.
CAUTION
To reduce risk offire and toproperly exhaust airoutside -Do not v ent exhaust airinto spaces within w alls, ceilings,
attics, crawl spaces orgarages.
OPERATION
Always leave s afety grilles and filters inplace. Without these c omponents, operating blowers could c atch o nto hair, fingers
and loose c lothing.
The manufacturer declines all r esponsibility inthe event offailure t oobserve the instructions given h ere f orinstallation,
maintenance and suitable use ofthe product. The manufacturer further declines allresponsibility forinjury due to
negligence and the warranty ofthe unit a utomatically expires due toimproper maintenance.
*NOTE: Please check www.zephyronline.com for revisions before doing any custom work.
O
dk=l
¢)
=
ELECTRICAL REQUIREMENTS
Important:
Observe all governing codes and ordinances.
It is the customer's responsibility:
- To contact a qualified electrical installer.
- To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70
latest edition* or CSA standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 - latest edition** and
all local codes and ordinances.
If codes permit and a separate ground wire is used, it is recommended that a qualified electrician determine that the
ground path is adequate.
Do not ground to a gas pipe.
Check with a qualified electrician if you are not sure the range hood is properly grounded.
Do not have a fuse in the neutral or ground circuit.
*National Fire Protection Association Batterymarch Park, Quincy, Massachusetts 02269
** CSA International 8501 East Pleasant Valley Road, Cleveland, Ohio 44131-5575
This appliance requires a 120V 60Hz electrical supply and connected to an individual properly grounded branch circuit
protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire with ground. Please also refer to
Electrical Diagram on product.
A cable locking connector (not supplied) might also be required by local codes. Check with local requirements, purchase
and install appropriate connector if necessary.