CAUTION : Never install the magnetron without the metallic gasket plate which is packed with each magnetron to
prevent microwave leakage. Whenever repair work is carried out on magnetron, check the microwave
leakage. It shall not exceed 4mW/cm
Metallic
Gasket
Plate
Cooling Fin
Magnetron
8. To remove fan motor assembly
(1) Remove two screws ¤ which secure the back cover ¤Ł from the cavity outer.
(2) Remove two screws ¤Øwhich secure the fan motor ¤Œ from the back cover ¤Ł .
(3) Pull out the fan ¤º from the fan motor ¤Œ .
(4) Reverse the above steps for reassembly.
9. To remove transformer
(1) Remove the two screws ¤ holding the H.V. trans-
former ¤Ł .
(2) Remove the transformer ¤Ł.
(3) Reverse the above steps for reassembly.
Magnetron
Antenna
Filament
Terminal
5
4
2
for a fully assembled oven with door normally closed.
Wave Guide
Metallic Gasket Plate
19
Magnetron Antenna
1
3
1
2