Dension AVR-9202-2 Installation Manual

By jvarga at 12:26 pm, 2/2/09
Introduction
Warning! Always make sure that your vehicle's battery is
disconnected before beginning installation and that you have
your head unit's (radio's) security code (if applicable).
The Dension AVR will enable you to access audio and visual data
from a seperate, aftermarket source (iPod, DVD etc.) and view it
on your vehicle's original head unit (radio) via a Gateway (GW) 500
module.
Please note that TV-Tuner activation may be required to enable
the AV input. Contact your dealer for more information. There are
also various options that will allow you to connect your aftermar-
ket source that would not be possible with the OE system (cam-
eras/rear seat entertainment etc.). Check the user guide for all
functions.
All photos/illustrations are for representation purposes only and may differ
visually from the equipment in your vehicle. Information correct at time of
going to print E. & O. E. Dension Audio Sytems Ltd. and it's registered partners
cannot be held liable for any damages caused by the incorrect installation of
any Dension product.
1
Porsche Cayenne PCM2 and Mercedes Comand
1. Carefully remove your vehicle's head unit as per the factory
instructions and using the correct tools.
2. Connect the AVR interface loom between the head unit and the
vehicle harness.
3. Connect the 12-way microfit connector from the interface loom
to the CAR port of AVR.
4. Insert the 9 pin male DIN from the AVR into the GW500 iPod port.
5. Connect the iPod loom from the GW500 to the female 9 pin DIN
port on the AVR.
6. Remove the cable from the green Video-In Fakra connector of
the radio and connect it to the yellow Video-In phono of AVR us-
ing the given Fakra-RCA converter cable.
7. Then connect the Video cable of "AV OUT TO HU" video output
from the 6-way microfit back into the radio using the other Fakra-
RCA converter cable.
8. Connect all remaining connections (Rear Seat displays, DVD,
Cameras, handbrake detect etc.) as per section 4.
2 BMW iDrive CCC
1. Carefully remove your vehicle's head unit as per the factory
instructions and using the correct tools.
2. Connect the AVR interface loom between the head unit and the
vehicle harness.
3. Connect the 12-way microfit connector from the interface loom
to the AVR.
4. Insert the 9 pin male DIN from the AVR into the GW500 iPod
port.
5. Connect the iPod loom from the GW500 to the female 9 pin DIN
port on the AVR.
6. On the 12-way microfit harness there is a break out for the video
input in the vehicle. The Vehicle side will connect into the (yellow)
Video-In phono RCA input of AVR. The return video must be then
connected into the head unit harness. All connections are on the
supplied harness.
7. Connect all remaining connections (Rear Seat displays, DVD,
Cameras, handbrake detect etc.) as per section 4.
Options
3
If you wish to use the factory TV-Tuner, please set the Gateway 500
to bypass mode. In this case all Gateway and AVR functionalites
will be disabled.
Depending on headunit capabilities the Video format of input/
output signals can be set to NTSC or PAL using a USB config file.
In most countries when the car is moving video is not permitted
by law on the head unit (this is the default, recommended con-
figuration of AVR).
Pending local regulations and user liability, the Video in Motion
support may be enabled on AVR using a USB config file.
Please see more details on the USB configuration files on the Den-
sion website.