Troubleshooting - TRENDnet TBW-105UB Quick Installation Manual

Hide thumbs Also See for TBW-105UB:

Troubleshooting

Q1:

Windows is unable to recognize my hardware. What should I do?

A1:

First, make sure your computer meets the minimum requirements as specified

in Section 1 of this Quick Installation Guide. Second, you must install the Bluetooth utility

BEFORE you physically install your Bluetooth Adapter. Third, plug the adapter into a

different USB slot.

Q2:

The Bluetooth software is unable to detect my Bluetooth-enabled device. What should

I do?

A2:

First, disable any software firewall programs such as ZoneAlarm or Norton Internet

Security. If your have Windows XP installed on your computer, make sure to disable the

built-in XP firewall. Second, make sure your Bluetooth device is powered on.

Q3:

I cannot pair my Bluetooth device to the TBW-105UB USB Adapter. What should I do?

A3:

First, make sure your Bluetooth device is powered on. Second, make sure that your

Bluetooth device is in pairing mode. Third, make sure to put in the same Bluetooth

Security Code on both devices.

Q4:

I am not receiving 3Mbps data rate through the adapter. What should I do?

A4:

In order to get the full data rate, your Bluetooth device must support Bluetooth v2.0 with

Enhanced Data Rate (EDR)

If you still encounter problems or have any questions regarding the TBW-105UB, please refer to

the User's Guide included on the Utility & Driver CD-ROM or contact TRENDnet's Technical

Support Department.

Table of Contents