Advertisement
Installation Instructions
Reference Enthalpy
Precedent™ Packaged Rooftop Units
3 to 25 Tons
Model Number:
Used With:
FIAENTH001*
3 to 25 tons with Symbio™ controls
Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of
heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
Improperly installed, adjusted or altered equipment by an unqualified person could result in death or serious injury.
When working on the equipment, observe all precautions in the literature and on the tags, stickers, and labels that are
attached to the equipment.
September 2024
SAFETY WARNING
ACC-SVN234C-EN
Advertisement
Table of Contents
Related Manuals for Trane Precedent FIAENTH001 Series
Summary of Contents for Trane Precedent FIAENTH001 Series
- Page 1 Installation Instructions Reference Enthalpy Precedent™ Packaged Rooftop Units 3 to 25 Tons Model Number: Used With: FIAENTH001* 3 to 25 tons with Symbio™ controls SAFETY WARNING Only qualified personnel should install and service the equipment. The installation, starting up, and servicing of heating, ventilating, and air-conditioning equipment can be hazardous and requires specific knowledge and training.
-
Page 2: Warnings, Cautions, And Notices
When working with or around hazardous chemicals, these compounds have the same potential impact to the ALWAYS refer to the appropriate SDS and OSHA/GHS environment. Trane advocates the responsible handling of all (Global Harmonized System of Classification and refrigerants. Labeling of Chemicals) guidelines for information on... -
Page 3: Revision History
Copyright This document and the information in it are the property of Trane, and may not be used or reproduced in whole or in part without written permission. Trane reserves the right to revise this publication at any time, and to make changes to its content without obligation to notify any person of such revision or change. -
Page 4: General Information
General Information Inspection 1. Unpack all components of the kit. 2. Check carefully for shipping damage. If any damage is found, report it immediately, and file a claim against the transportation company. Note: If fresh air options module is not installed in the unit, it has to be purchased. -
Page 5: Installation
Installation Figure 2. Secure sensor with screws WARNING Hazardous Voltage w/Capacitors! Failure to disconnect power and discharge capacitors before servicing could result in death or serious injury. Disconnect all electric power, including remote disconnects and discharge all motor start/run capacitors before servicing. Follow proper lockout/ tagout procedures to ensure the power cannot be inadvertently energized. - Page 6 Installation Figure 4. Wire routing to fresh air options module Figure 6. Sensor location for A, B, and C cabinet standard economizer (digit 39 = A, B, C) 7. Replace mist eliminator. 8. Replace mist eliminator retaining angle by sliding one slotted end of the retaining angle onto the loosened screw and replace the screw on the other end of the retaining angle.
- Page 7 Installation Figure 7. Sensor location for A, B, and C cabinet low leak economizer (digit 39 = A, B, C) OAH Sensor Bushing Figure 8. Outdoor Sensor location for A, B, and C cabinet horizontal low leak economizer (digit 39 = A, B, C) Bushing Pop-In Wire Tie...
- Page 8 Installation Figure 9. Sensor location for D cabinet standard economizer (digit 39 = D) Bushing OAH Sensor Figure 10. Sensor location for D cabinet low leak economizer (digit 39 = D) Bushing OAH Sensor Pop-In Wire Tie (a) Uninstalled components are located in the return enclosure. Refer to Figure ACC-SVN234C-EN...
- Page 9 Notes ACC-SVN234C-EN...
- Page 10 Notes ACC-SVN234C-EN...
- Page 11 Notes ACC-SVN234C-EN...
- Page 12 For more information, please visit trane.com or americanstandardair.com. Trane and American Standard have a policy of continuous product and product data improvement and reserve the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.
Need help?
Do you have a question about the Precedent FIAENTH001 Series and is the answer not in the manual?
Questions and answers