Canon RealIS SX80 Mark II User Manual page 6

CHAPTER 1 • Introduction
3
To configure a broadcast address, select the [Broadcast] tab and click the [New]
button.
[Specify broadcast discovery settings] dialog will display.
Note
4
Complete the dialog with necessary information and click the [OK] button.
Broadcast address
Community Name
Timeout
Password
(SNMP V3 only)
Enable encryption
(SNMP V3 only)
5
To specify an IP address range, select the [IP address ranges] tab and click
the [New] button.
[Specify IP address range] dialog will display.
6
- As default, broadcast settings configured on the network card of the
administrative computer will display in the discovery range list.
Category
Enter a broadcast address of the network to discover in "XXX.
XXX.XXX.XXX" form.
Enter a community name within 15 one-byte alphanumeric
characters and symbols.
Enter a number of seconds to time out, from 1 to 9.
Enter a password within 8 to 15 one-byte alphanumeric
characters and symbols.
Place a checkmark if encrypted. Remove a checkmark if not.
Description